This page covers the use of Squid in a multi-tenant situation - i.e. with multiple IP address that can be assigned based on where in your OpenAthens domain a user sits.

This page concentrates on Linux. Other forwarding proxies are available and will work in similar ways.

Prerequisites

Method

 There are a couple of differences between Debian and Red Hat derived systems which are highlighted below. Other distros will be similar.

General

  1. Install Squid. Most repositories include it, but you can also get binaries from https://wiki.squid-cache.org/SquidFaq/BinaryPackages

  2. Navigate to your install directory (/etc/squid)

  3. Edit squid.conf taking care to use the correct auth_param line for your distro.

    # Prevent X-Forwarded-For being overwritten by Squid
    forwarded_for transparent
     
    # Setup ACLs for OpenAthens
    auth_param basic program /usr/lib64/squid/basic_ncsa_auth /etc/squid/squid_users # RHEL / CentOS based distros
    # auth_param basic program /usr/lib/squid/basic_ncsa_auth /etc/squid/squid_users # Debian / Ubuntu based distros
    auth_param basic realm proxy
    acl authenticated proxy_auth REQUIRED
    include /etc/squid/acl.conf
     
    # Allow authenticated access
    http_access allow authenticated
     
    # Deny all other access to this proxy
    http_access deny all

    Three necessary files /etc/squid/acl.conf/etc/squid/squid_users and /etc/squid/addresses.conf (referenced later) define the ACLs and mappings to IP addresses. These will be supplied by OpenAthens.

  4. Start Squid and set it to autostart according to your OS

  5. <squids_ip_address>:3128 should now show an error page generated by Squid

Securing the connection

You want to make sure that the inbound connection is limited to OpenAthens and this is secured using an X.509 client certificate. The squid_users file is used purely for mapping. 

The process is a little different depending on which flavour of Linux you are using. 

Red Hat based distros such as CentOS

6. Add the following to your squid.conf file:

#http_port xxx.xxx.xxx.xxx:3128 
 
https_port xxx.xxx.xxx.xxx:3128 cert=/etc/squid/ssl_cert/server.pem clientca=/etc/squid/ssl_cert/openathens-client.pem

8. Set your firewall rules to

9. Securely pass our service desk the username and password you set up in step 3 





Debian based distros such as Ubuntu

At the time of writing the Squid package supplied by Debian is not compiled with the -enable-ssl flag which means the https_port configuration directive is not available and a little more work is required. Since you can't use a simple configuration directive you need to front Squid with something such as stunnel (https://www.stunnel.org/).  

6.  >apt-get install stunnel4

8. Create /etc/stunnel/stunnel.conf:

pid=/var/run/stunnel4/pid
setuid = stunnel4
setgid = nogroup
 
[squid-tls]
accept  = xxx.xxx.xxx.xxx:3128
#Don't need to expose squid directly to the internet.
connect = 127.0.0.1:3129
cert = /etc/stunnel/server.pem
CAfile=/etc/stunnel/openathens-client.pem
verify = 4

9. Add the following to your squid.conf file:

http_port 127.0.0.1:3129

10. Set your firewall rules to

11. Securely pass our service desk the username and password you set up in step 3.